Hakko FT700 Tip Polisher With FS100 Paste

Click on above image to view full picture

More Views

  • Hakko FT700 Tip Polisher With FS100 Paste
  • Hakko FT700 Tip Polisher With FS100 Paste

Hakko FT700 Tip Polisher With FS100 Paste

Hakko Soldering & Desodering Equipments
Hakko FT700 Tip Polisher is a device that is used for polishing the soldering tip. Polishing helps removal of oxidized material that is firmly present on the soldering tips. Polishing does not damage the soldering tip. However, it eventually increases the life of soldering tips. While polishing you must use the Chemical Paste HAKKO FS-100. The paste does not include any amount of Ammonium phosphate. If HAKKO FS 100 fails to remove the oxidized material, you can use the brush to remove the oxidized material. The use of this brush may produce small scratches on the iron plating surface of the tip.
OR

 

"Maintenance kit for oxidized soldering tips"
Especially suitable for soldering tips oxidized by Lead-free solder and high temperature solder 
By using the brush and accessory "Chemical Paste"HAKKO FS-100:
 
Oxidation can be removed without causing damage to the soldering tip
Diamnonium phosphate is not included
Power saving with 3 power consumption.
HAKKO FT-700 Tip Polisher / Tip condition before and after polishing with HAKKO FT-700 tip polisher

 

· Operation
 
Oxidized tip
Oxidized tip
Use a temperature setting of around 350ºC. Re-tinning is now completed.
Re-tinning is now completed.
↓           右
Remove the oxidation.
Remove the oxidation.
右 Re-tin the tip.
Re-tin the tip.
右 Clean off FS-100 paste from tip surface.
Clean off FS-100 paste from tip surface.
右  Feed solder onto tip.
Feed solder onto tip.
    右
Repeat the process twice or more.

NOTE: When the tip temperature is over 400ºC, even if the oxidation film is removed by "HAKKO FT-700 tip polisher", the tip can turn to be oxidized quickly again.


When the oxidation cannot be removed by the above procedure
When the oxidation is hard, it sometimes cannot be removed even by the HAKKO FT-700. In this case, use the brush which is included in the unit as the accessory.
Remove oxidation film using brush included with HAKKO FT-700   Remove oxidation film with HAKKO FT-700 tip polisher   Retin using HAKKO FS-100 chemical paste
(1) Remove oxidation the brush.   (2) Clean with FT-700   (3) Re-tin with HAKKO FS-100 and perform the operation No.3 and 4.
NOTE: When the brush is used, small scratches may be produced on the iron plating surface of the tip.
Do not always use the brush, but use only when oxidation cannot be removed by cleaning with HAKKO FT-700.

 

Model No.FT-700
Power consumption 3W (100V), 4.5W (110 to 120V, 220 to 240V)
Dimensions 70(W)×54(H)×101(D)mm
Weight 0.65kg

・Chemical Paste Fs-100

Amount 10g
Ingredients Flux, tin(Sn) 50wt%(each)